BMW 3: Concept, General information
Concept
Driver profiles can be created to store personal vehicle settings. If the vehicle is used by multiple drivers, each driver can create his personal driver profile. When a driver profile is selected, the vehicle will automatically apply the stored settings in the driver profile.
General information
Three personal driver profiles can be created.
In addition, a guest profile is available that can be selected by any driver. The guest profile is active when a personal driver profile has not been selected.
Changes to the vehicle settings are automatically stored in the active driver profile or in the guest profile.
The recognition via vehicle key and a digital key can be assigned to a driver profile so that the vehicle will apply the settings as soon as the driver unlocks the car. As soon as the vehicle detects the vehicle key or the digital key, the corresponding driver profile will be activated.
ConnectedDrive countries: The settings stored in the driver's profile can be synchronized with the personal BMW ConnectedDrive account. It is thereby possible to use these settings in other BMW vehicles as well.
Functional requirements
When switching the driver profile, the vehicle must move at a maximum of walking speed.
Welcome screen After the Control Display is switched on, the Welcome screen will be displayed.
The following actions can be carried out on the
Welcome screen:
- Switching the driver profile.
- Starting the set-up assistant.
This option is offered in new vehicle for a limited period of time.
As soon as the engine is started or any button is pressed, the Welcome screen will be hidden.
READ NEXT:
Setup assistant
The setup assistant is offered in new vehicles for
a limited period of time on the Welcome screen
to configure the most important settings for the
vehicle.
"Getting started" Select to start the set-u
Creating a driver profile
A driver profile is created or via iDrive:
1. "CAR".
2. "Driver profiles".
3. Move the Controller to the right.
As an alternative for Steps 1 to 3, the profile
image can be tapped in the top status
Changing/canceling the
recognition function
If another vehicle key or another digital key is to
be assigned to a driver profile, the current assignment
must be canceled first.
Via iDrive:
1. "CAR".
2. "Driver profiles".
3. Move the Controlle
SEE MORE:
Operating strategy
The following graphic shows the positions of the rotary valve as the coolant
temperature increases:
Switching diagram heat management module
0% - Rotary valve closed
100% - Rotary valve open
Cold start
Warm-up phase
Operating temperature
Transition from normal operation to maximum cooling req
Speed warning
Concept
A speed limit can be set that when reached will
cause a warning to be issued.
General information
The warning is repeated if the vehicle speed exceeds
the set speed limit again, after it has dropped
below it by 3 mph/5 km/h.
Adjusting
Via iDrive:
1. "CAR".
2. "Settings".
3. "General settin
