BMW 3: Switching on/off and interrupting cruise control
With steering and traffic jam assistant: Assisted Driving
General information
.png)
This button is used to switch the
configured
function on and off.
.png)
The button can be used to set the
primarily
used function.
Set function
1. When the system is active,
press the
button repeatedly until the desired function is
selected in the function bar. The function bar for Assisted Driving is displayed
at the bottom
of the instrument cluster.
.png)
Cruise control with distance
control..png)
Depending on the equipment
version,
cruise control with distance control
and steering and traffic jam assistant..png)
Depending on the equipment
version,
cruise control with distance control
and steering and traffic jam assistant.
The selected function is shown in green.
The setting is stored for the driver profile currently used.
Switching on
With steering and traffic jam assistant:
1. .png)
Press the button on the
steering
wheel.
2. .png)
If necessary, set the cruise
control.
Without steering and traffic jam assistant:
.png)
Press the button on the steering
wheel.
The indicator lights in the instrument cluster light up and the marking on the speedometer is set to the current speed.
Cruise control is active. The current speed is maintained and stored as desired speed.
DSC Dynamic Stability Control is switched on, if necessary.
Switching off
To switch off the system while standing, step on brake pedal at the same time.
Press the button on the steering wheel:
.png)
Without steering and traffic jam
assistant.
.png)
With steering and traffic jam
assistant.
The displays go out. The stored desired speed is deleted.
Interrupting manually
When active, press the following button on the steering wheel:
.png)
Without steering and traffic jam
assistant.
.png)
With steering and traffic jam
assistant.
If interrupting the system while stationary, press on the brake pedal at the same time.
Interrupting automatically
The system is automatically interrupted in the following situations:
- When the driver applies the brakes.
- When selector lever position D is disengaged.
- Dynamic Traction Control DTC is activated or DSC Dynamic Stability Control is deactivated.
- If DSC Dynamic Stability Control intervenes.
- If the safety belt is unbuckled and the driver's door is opened while the vehicle is standing still.
- If the system has not detected objects for an extended period, for instance on a road with very little traffic without curb or shoulder markings.
- If the detection range of the radar is impaired, for instance by dirt or heavy fog.
- After a longer stationary period when the vehicle has been braked to a stop by the system.
READ NEXT:
Setting the speed
Maintaining and storing the speed
Press the rocker switch up or down once while
the system is interrupted. The system will be activated.
The current speed is maintained and stored as
desired speed.
Displays in the instrument
cluster
General information
Depending on the equipment version, the displays
in the instrument cluster may vary.
Display in the speedometer
Green marking: system is
active,
the marking indicates the
de
System limits
Detection range
The detection capacity of the system and the
automatic braking capacity are limited.
Two-wheeled vehicles for instance might not be
detected.
Deceleration
The system does not deceler
SEE MORE:
Shift point indicator
Concept
The shift lights indicate the upshift point at which
the best possible acceleration can be achieved.
Functional requirement
Shift lights are shown when the SPORT or
SPORT PLUS driving program is activated.
Switching on/off
Steptronic Sport transmission:
1. Select SPORT or SPORT PLUS driving
Removing the flat high-voltage connector
Bridge for high-voltage interlock loop
Before the high-voltage connector can be
disconnected, the bridge for the high-voltage
interlock loop must first be removed. The bridge
closes the circuit of the high-voltage interlock
loop in a connected state. The SME and EME
control units continuous
