BMW 3: Renaming a driver profile
Countries in which ConnectedDrive is not available:
The name that was assigned when the driver profile was set up can be changed via iDrive:
1. "CAR".
2. "Driver profiles".
As an alternative for Steps 1 and 2, the profile image can be tapped in the top status bar.
3. Select driver profile.
4. "Settings".
5. Enter a profile name.
6. 
Select the symbol.
Selecting a profile picture
Countries in which ConnectedDrive is available: The profile image is transferred from the ConnectedDrive portal or the BMW Connected app.
Countries in which ConnectedDrive is not available: Via iDrive:
1. "CAR".
2. "Driver profiles".
3. Move the Controller to the right.
As an alternative for Steps 1 to 3, the profile image can be tapped in the top status bar.
4. "Avatar".
5. Select the desired profile picture.
Deleting the driver profile
Via iDrive:
1. "CAR".
2. "Driver profiles".
3. Move the Controller to the right.
As an alternative for Steps 1 to 3, the profile image can be tapped in the top status bar.
4. "Settings".
5. "Remove driver profile".
6. Select the desired driver profile.
7. "Delete now".
ConnectedDrive countries: If the driver profile was synchronized with a ConnectedDrive account, the stored data in the ConnectedDrive account will be retained.
System limits
A clear detection of the desired vehicle key may not be possible in the following cases, e.g.:
- The driver unlocks the vehicle via Comfort Access.
- The driver changes, but the vehicle is not locked and unlocked.
- When multiple vehicle keys are located outside on the driver's side of the vehicle.
ConnectedDrive countries: A driver profile can only be created and synchronized with the ConnectedDrive account when cellular network reception is available.
The use of personal settings that are stored in the ConnectedDrive account in other vehicles is subject to technical limitations. For example, settings may be stored for a system that is not available, or available in a non-compatible version, in other vehicles.
READ NEXT:
Connecting mobile devices
to the vehicle
Concept
Various connection types are available for using
mobile devices in the vehicle. The connection
type to select depends on the mobile device and
the desired function.
General information
The fol
SEE MORE:
Removing the flat high-voltage connector
Bridge for high-voltage interlock loop
Before the high-voltage connector can be
disconnected, the bridge for the high-voltage
interlock loop must first be removed. The bridge
closes the circuit of the high-voltage interlock
loop in a connected state. The SME and EME
control units continuous
Areas to be avoided
Concept
Areas that should be driven around can be specified
as areas to be avoided.
General information
Stored areas to be avoided can be activated and
deactivated.
Defining an area to be avoided
1. Select the area to be bypassed on the map.
2. Press the button on the
Controller.
3. Press the Co
