BMW 3: Received destinations
General information
Depending on the national-market version, the destinations are automatically stored as received destination and can be applied in the destination guidance, if they were transferred to the vehicle via the BMW Connected app.
For example, destinations that were sent from the Concierge Service can be stored in the received destinations.
Open destination from received destinations
1. 
Press the button on the
Controller.
2. 
"Received destinations"
3. Select the destination.
Enter the destination via GPS coordinates
Concept
Destinations can be entered directly using GPS coordinates.
General information
Enter the coordinates in degrees, minutes and seconds or as decimal values.
Entering a destination
1. 
Press the button on the
Controller.
2. 
"GPS coordinates".
3. "Format":
- "Deg Min Sec"
- "Decimal"
4. "Longitude" or "Latitude".
5. Enter the desired degrees and direction.
6. Enter the values for minutes and seconds and direction, if needed.
7. "Apply coordinates".
READ NEXT:
Planning a trip
General information
When planning a trip, several intermediate destinations
can be entered.
New trip
1. Press the button on the
Controller.
2. Select the type of destination entry.
3. Select a sing
Stored trips
General information
Up to 30 trips can be stored in the trip list. If necessary,
delete existing trips to be able to store
new trips.
Storing
The destination guidance for the tip must be active.
1. P
SEE MORE:
Automatic climate control - switching on/off
Switching on
Press any button except for the following:
Switching off.
Rear window defroster.
Lower air flow button side.
Seat heating.
Switching off
Complete system:
Press the button until the
control panel
switches off.
Temperature
Concept
The automatic climate control achieves the set
temp
Engine Electrical System
Digital Motor Electronics (DME)
DME 8 control unit
The Digital Motor Electronics (DME) is the computing and switching center.
Sensors on the engine
and the vehicle deliver the input signals and actuators implement the commands.
The Digital Motor
Electronics (DME) calculates the corresponding acti
