BMW 3: Quick search
Concept
Depending on the equipment, Points of Interest
and addresses can be searched for by entering a
sequence of letters or by searching in the navigation
data stored in the vehicle.
All entries are displayed that include this text
string.
General information
It is possible to search simultaneously by town/
city and street. To do this, enter a text string for
the town/city, then a blank space and a text string
for the street name.
Calling up quick search
1.
Press the button on the
Controller.
2.
"Where to?"
3. Enter at least two letters or characters.
The search term may be completed automatically
in gray print.
Move the controller up to apply the suggested
search term.
4.
Select the symbol, if needed.
Results are displayed in a list.
For vehicles with charging socket: charging
station display.
5. "Search location": select search location.
6. Move the Controller to the right.
7. Select desired destination.
READ NEXT:
General information
The previous destinations driven to are stored
automatically.
Open the destination from the
last destinations
1. Press the button on the
Controller.
2. "Recent destinations".
3.
General information
Instructions for the voice activation system,
see vehicle Owner's Manual.
When making a destination entry by voice,
you can change between voice operation and
iDrive.
To hav
General information
The home address must be created to apply it as
a destination.
Defining the home address
1. Press the button on the
Controller.
2. "Set home address".
3. Enter the address.
Usi
SEE MORE:
The DC/DC converter in the Electrical Machine Electronics of the G20 PHEV is
able to adopt the
following operating modes:
Standby (also in the event of a component fault or short circuit, power
electronics off)
Buck mode (energy flow to the low-voltage side, converter adjusts
voltage on
Concept
Pressing the Start/Stop button
switches drive-ready state on or
off.
Steptronic transmission: the
drive-ready state is switched on
when you depress the brake pedal while pressing
the Start/Stop button.
Pressing the Start/Stop button again switches
drive-ready state back off and standby sta